Code Alarm Automobile Alarm HQ7405 User Manual

Model CATX510

Programming Guide

The keychain transmitters included with the system have been pre-

programmed at the factory, with each button pre-assigned to control a specific

function of the system.

The system will store codes from up to 4 different transmitters. If a 5^th

transmitter is programmed to the system, then the first transmitter

programmed to the system will be erased from the system’s memory.

To program new or additional transmitters:

1. Enter the vehicle, and turn the ignition switch to the ON position.

2. Press and release the programming button switch 3 times.

3. The dash mounted LED will flash 1 time, and the parking lights will flash 1

time, indicating that the system is ready to accept programming of channel 1

which is LOCK.

4. Press and hold the lock icon button of the transmitter you wish to program

for 4 seconds or until a long flash from the parking lights.

4a. Repeat step 4 for any additional transmitter you wish to program.

5. Press and release the programming button switch 1 time to advance to

channel 2. The parking lights will flash 2 times and the dash mounted LED will

flash 2 times, indicating that the system is ready to accept programming for

channel 2 which is UNLOCK.

6. Press and hold the unlock icon button of the transmitter you wish to

program for 4 seconds or until a long flash from the parking lights.

6a. Repeat step 6 for any additional transmitter you wish to program.

7. Press and release the programming button switch 1 time to advance to

channel 3. The parking lights will flash 3 times and the dash mounted LED will

flash 3 times, indicating that the system is ready to accept programming for

channel 3 which is REMOTE START.

8. Press and hold both buttons simultaneously of the transmitter you wish to

program for 4 seconds or until a long flash from the parking lights.

8a. Repeat step 8 for any additional transmitter you wish to program.